[strings.0409]
; Localizable strings
brcm = "Broadcom Corporation"
MSFT = "Microsoft"

F_NAME0 = "Broadcom NetLink (TM) Gigabit Ethernet"
F_NAME1 = "Broadcom NetLink (TM) Fast Ethernet"
F_NAME2 = "Broadcom NetLink (TM) Ethernet"
WireSpeed                               = "Ethernet@WireSpeed"
WireSpeed_Disable                       = "Disable"
WireSpeed_Enable                        = "Enable"
ParamDesc_InterruptModeration = "Interrupt Moderation"
GenDisable                                                      = "Disabled"
GenEnable                                                       = "Enabled"
ParamDesc_GSOv4                                 = "Large Send Offload V2 (IPv4)"
ParamDesc_GSOv6         = "Large Send Offload V2 (IPv6)"
ParamDesc_TCPUDPChecksumOffloadIPv6 = "TCP/UDP Checksum Offload (IPv6)"
GenTxEnable                                             = "Tx Enabled"
ParamDesc_IPChksumOffv4  = "IPv4 Checksum Offload"
ParamDesc_TCPUDPChecksumOffloadIPv4 = "TCP/UDP Checksum Offload (IPv4)"
GenRxEnable                                             = "Rx Enabled"
GenTxRxEnable                                   = "Rx & Tx Enabled"
ParamDesc_RSS                                   = "Receive Side Scaling"
ParamDesc_RSS_Queues = "Maximum Number of RSS Queues"
RSS_Queues_1 = "RSS 1 Queue"
RSS_Queues_2 = "RSS 2 Queues"
RSS_Queues_4 = "RSS 4 Queues"
ParamDesc_LSOv4                                 = "Large Send Offload (IPv4)"
LogLevelInfo            = "Log Information Messages"
LogLevelInfo_Disable    = "Disable"
LogLevelInfo_Enable     = "Enable"
LogLevelWarn            = "Log Warning Messages"
LogLevelWarn_Disable    = "Disable"
LogLevelWarn_Enable     = "Enable"
FlowControl             = "Flow Control"
FlowControl_Disable     = "Disabled"
FlowControl_Rx_Pause    = "Tx Enabled"
FlowControl_Tx_Pause    = "Rx Enabled"
FlowControl_Rx_Tx_Pause = "Rx & Tx Enabled"
NetworkAddress                                  = "Network Address"
PriandVlan              = "Priority & VLAN"
PriVlanDisabled         = "Priority & VLAN Disabled"
PriEnabled              = "Priority Enabled"
VlanEnabled             = "VLAN Enabled"
PriVlanEnabled          = "Priority & VLAN Enabled"
VlanID                  = "VLAN ID"
WakeOnMagicPacket       = "Wake on Magic Packet"
WakeOnPattern           = "Wake on Pattern Match"
WolSpeed                                        = "WOL Speed"
WolSpeed_Auto                                   = "Auto"
WolSpeed_10mb                                   = "10 Mb"
WolSpeed_100mb                                  = "100 Mb"
WolSpeed_LowestAvail            = "Lowest Speed Advertised"
Speed_Duplex            = "Speed & Duplex"
Speed_Duplex_Auto       = "Auto Negotiation"
Speed_Duplex_10Mb_Hd    = "10 Mbps Half Duplex"
Speed_Duplex_10Mb_Fd    = "10 Mbps Full Duplex"
Speed_Duplex_100Mb_Hd   = "100 Mbps Half Duplex"
Speed_Duplex_100Mb_Fd   = "100 Mbps Full Duplex"
ParamDesc_PmArp ="ARP Offload"
ParamDesc_PmNs  ="NS Offload"
JumboMtu = "Jumbo Mtu"
EEE                     = "802.3az EEE"
EEE_Disable             = "Disable"
EEE_Enable              = "Enable"

EEE_Control				= "EEE Control Policies"
EEE_MaxPowerSave		= "Maximum Power Saving"
EEE_Balance				= "Optimal Power and Performance"
EEE_MaxPerformance		= "Maximum Performance"

DISK_DESC           = "Broadcom NetLink Installation Media"
SvcDispName         = "Broadcom NetLink (TM) Gigabit Ethernet - NDIS 6.0"